BondTech HeatLink 300C Thermistor, 1 Pc

Bondtech HeatLink 300 ° C thermistor

The 300C thermistor is based on the SeMitec 104NT-4-R025H42G temperature sensor and uses a Molex Micro-Fit 3.0 socket to extend it with one of the HeatLink interface cables and to be able to easily connect it to your printer.

• 1.5 m long cable with blue grommets and Molex Micro-Fit 3.0 socket
• Ø 3 mm stainless steel crimp cartridge with laser-engraved Bondtech logo
• SeMitec 104NT-4 temperature sensor

The HeatLink range is an alternative group of thermistors and heating cables equipped with Molex Micro-Fit connectors and complemented by several short interface cables to connect to dozens of 3D printer models for ease of use for their owners.

HeatLink is an offer for the growing demand for more powerful components for heat generation and readout while at the same time being easy to install.

Simply couple your Bondtech thermistor or heater with a HeatLink cable and connect it to almost any 3D printer.

Each interface cable is 50 mm long and fits completely into the control box.

Bondtech HeatLink Interface Cable (Thermistor) Compatibility Chart